Ts1162 Installation Manual Exclusive |best| -
, the general physical installation steps for this series of RAS keypads include: support.firesecurityproducts.com.au The unit can be mounted indoors or outdoors.
The housing the drive (TS4500 library or standalone)
+-----------------------------------------------------------+ | TS1162 REAR INTERFACE | | | | [ FC Port 1 ] [ FC Port 2 ] [ Ethernet ] [ Power ] | | (Primary) (Failover) (Management) (Input) | +-----------------------------------------------------------+
Thread the TS1162 into the port by hand until it seats. The exclusive manual requires that you feel resistance exactly at 1.5 turns after initial contact. If you feel resistance earlier, cross-threading has occurred. ts1162 installation manual exclusive
The manual includes a diagram showing a 100-ohm resistor placed between Pin 2 and chassis ground only if you experience ground loop noise. Without this exclusive diagram, technicians often short the shield to Pin 2, causing catastrophic drift.
Log in using the administrator credentials listed in your factory package.
The TS1162's unique housing can be installed directly on a . Ensure the mounting surface is flat, solid, and vertical so the base will not flex when screws are tightened. , the general physical installation steps for this
Run the itdt (IBM Tape Diagnostic Tool) scanning tool to ensure the operating system properly discovers the drive: ./itdt scan Use code with caution. 6. Media Compatibility and Maintenance Protocols
Wire the open collector output to the relay coil or access control strike (ensure you utilize a flyback diode on the relay coil to protect the TS1162's PCB from inductive voltage spikes). 💻 Panel Programming and Configuration
Maintenance and care
: Mount the device at an accessible height (typically 1.2 meters nominal) [1.1]. Ensure the rear optical tamper sensor sits flush against a completely flat, non-flexing wall surface to prevent false tamper conditions.
What or panel type (e.g., Challenger10 vs ChallengerPlus) are you integrating this with?
Install the latest IBM Tape Device Driver package on your host operating system (Windows Server, Linux, or AIX). If you feel resistance earlier, cross-threading has occurred
