Bosch Qv60-rgc1 Manual ~upd~ -

Understanding the exact physical and electrical operating limits of the ensures safe operation and long-term hardware reliability. Specification Detail Manufacturer Bosch Rexroth Part Numbers 0 811 405 104 / B 830 303 386 Card Format Eurocard format (100 x 160 mm) for 19-inch rack mounting Power Supply Input 24 V DC nominal Control Interface Analog current/voltage inputs (e.g., 4–20 mA, 0–10 V) Output Stage Closed-loop current control with PID action Safety Features Short-circuit proof outputs & open-circuit cable monitoring Core Functional Modules

: Requires a standard industrial 24 V DC supply (functional range typically 21 V to 40 V).

Because long or highly capacitive feedback cables shift signal accuracy, you must balance the zero offset. Connect a multimeter to the actual value measurement socket on the front face of the card and adjust the until the rest state reads exactly 0V. Step 2: Sensitivity (Gain) Adjustment

The primary role of the QV60-RGC1 is converting an analog command input (such as a voltage or current loop signal from a PLC) into a robust, pulse-width modulated (PWM) output that drive proportional solenoids.

: The board coordinates with an inductive position transducer (typically operating around an oscillator frequency of 2.5 kHz) to track mechanical travel precisely. Terminal Strip & Pin Assignment (DIN 41612) bosch qv60-rgc1 manual

A green LED on the front panel typically signals "Ready for Operation." Typical Adjustment & Commissioning

Adjustable ramp times (typically 0.02 s to 5 s or 0.2 s to 50 s) Protection: IP00 (requires cabinet mounting) Electrical Connection: 32-pin connector (DIN 41612) 3. Installation and Setup Guide The installation of the should be performed by qualified personnel. 3.1 Mounting

Slide the card into a standard 19-inch rack (3U height). Connection: Ensure the 32-pin connector is securely seated.

: Use the part number 0 811 405 104 . Visit the official Bosch Rexroth website and navigate to their "Products" or "Download Center" section. Enter the part number into their search bar to find any available technical data sheets. Alternatively, contact a Bosch Rexroth authorized distributor or sales representative and provide them with the same part number. Connect a multimeter to the actual value measurement

: Includes LED indicators for status monitoring, such as "Enable" (green), "Feedback signal open circuit" (yellow), and "Fault" (red). Wiring & Adjustments Front Panel Controls

Related search suggestions:

: Wire the pulse-width modulated output pins directly to the hydraulic valve coil connections. Verify that maximum current demands align with the board ratings. Manual Commissioning & Potentiometer Calibration

Anchor the bracket using M8 expansion bolts. Hang the unit and verify it clicks securely into the lower locking tabs. Step 2: Refrigerant Piping Connections Line Sizes: Liquid Line (1/4 inch), Gas Line (1/2 inch). Terminal Strip & Pin Assignment (DIN 41612) A

The manual emphasizes connecting to a power source until you’ve inspected the unit for shipping damage. Once confirmed:

: To release the output stage and initialize the PID controller, a voltage input higher than must be fed into the Enable input terminal. Potentiometer Calibration Procedures

command value applied, adjust the "Zero" potentiometer until the hydraulic valve is centered or at its exact mechanical baseline.