Nako Na613d User Manual Exclusive 〈2025-2027〉
Press the key once; the minute digits will begin to flash. Tap or hold the D key to advance to the correct minute. Press the S key again to make the hour digits flash. Tap the D key to cycle to your desired hour.
: In normal mode, hold 'S' and press 'D' simultaneously; an alarm symbol will appear when active. Using the Stopwatch (Sport Watch Function) :
Press S to make the weekday bars flash along the top margin. Use D to select the correct day. nako na613d user manual exclusive
A: Make sure the alarm is turned on. Look for a bell icon on the display. If it's not there, press the S (LAP) and D (START) buttons at the same time to enable it.
Before every major session, perform this test: Press the key once; the minute digits will begin to flash
The Complete Nako NA-613D User Manual: Exclusive Guide to Settings, Alarms, and Troubleshooting
The Nako NA613D can be used in two ways: Tap the D key to cycle to your desired hour
Press the button while paused to reset the stopwatch back to zero.
From the screen, you can toggle the audio alerts:
| Cause (from manual) | Solution | | :--- | :--- | | Outfeed table is 0.2mm too low | Raise outfeed table using hex screw under the table | | Roller pressure uneven | Adjust spring tension on infeed roller (Section 7.3) |
The motor’s torque curve peaks at 1,600 RPM. Exceeding these depths will trigger the thermal overload protection, which requires a 15-minute cooldown.
