The Cobra 3195 uses diagnostic LED flash patterns to communicate why an alarm was triggered or why a component is failing. Alarm Trigger Memory Diagnostics
Enter your 4-digit PIN code using the dash button (e.g., 1 flash = number 1). 6. Troubleshooting
Cobra 3195 Alarm System: The Complete Installation, Operation, and Troubleshooting Guide cobra 3195 alarm manual full
Press the unlock button on the remote. The siren will beep twice, and the LED will stop flashing. Emergency Override (Lost Remote) If the remote fails, you can disarm the system: Open the door with the key (alarm will sound). Turn ignition ON.
If your remote control fails, is lost, or suffers from local radio frequency (RF) interference, you can disarm the system using your unique 4-digit PIN code. This code is found on the plastic code card supplied with the alarm at the time of installation. The Cobra 3195 uses diagnostic LED flash patterns
Press the Large Button once while the system is armed.
Allows the user to trigger the siren remotely in an emergency. Turn ignition ON
Turn the ignition OFF . Wait for the LED to flash 4 times , then immediately turn the ignition ON .
To arm or disarm the system without the audible chirp confirmation: Press quickly, followed immediately by Button A . 4. Emergency Disarm via PIN Code
Press on the new remote once. The car's dashboard LED will flash once to confirm the remote code has been stored.
Automatically cuts critical electrical circuits to prevent hotwiring.