Lambert Lx 24 Fi Manual English -

If the boiler remains idle for 24 hours, the electronic control board automatically runs the circulation pump for 1 minute to prevent seized bearings. Annual Service Requirements

Adjusts the target temperature for your radiators (typically between 30∘C30 raised to the composed with power C 85∘C85 raised to the composed with power C

Replace worn seals to prevent dangerous gas or water leaks. User Maintenance Tasks

Natural Gas (G20) or LPG (G31) with appropriate injector conversion kits.

Low Water Pressure. The system pressure has dropped too low. Refill using the filling loop as described above. Lambert Lx 24 Fi Manual English

Use the radiator-symbol plus/minus keys to dial your ideal loop temperature (typically set between 35°C and 80°C depending on insulation type).

This article serves as a comprehensive guide to the , covering installation, operation, safety, and troubleshooting based on standard Baxi/Baymak operation procedures. 1. Introduction to the Lambert LX 24 Fi Boiler

Understanding the base capabilities of your boiler helps in identifying if the system is performing correctly. Approximately 24 kW (82,000 BTU/hr).

3-star efficiency according to European Directive 92/42/EEC 2. Control Panel and User Interface If the boiler remains idle for 24 hours,

Its wall-mounted nature (725mm height) fits well in smaller spaces like kitchens. No Smart Features:

If the boiler displays a lockout symbol (red LED steady), pressing Reset once may clear it. If the code returns within 24 hours, professional assistance is required.

: Before first use, ensure the circulation pump is not stuck.

While a direct English PDF is not widely hosted, you can access the following resources: Low Water Pressure

Do not install the boiler above cooking appliances or in highly humid environments like bathrooms unless specifically permitted by local building codes. Flue Installation:

button (often labeled K5) until symbols for the radiator and tap appear on the display. Adjusting Temperature

The Lambert Lx 24 Fi is a 4-stroke, forced-air-cooled, single-cylinder, electronic fuel injection (Fi) engine. It is designed for reliable operation in industrial and domestic applications.

Open the filling loop underneath the boiler until pressure reaches 1.2 bar. Circulation Failure

To get your boiler up and running, follow these standard procedures:

The pressure gauge should be checked regularly. If the pressure drops below 0.5 bar, the boiler may not start. To increase pressure: Locate the filling loop (usually under the boiler).