 |
|
Connect your meter to your PC. If your computer doesn't automatically recognize the device, you may need to install the CH340 or PL2303 serial-to-USB drivers, which are commonly used by Satlink hardware. 3. Run the Upgrade Tool
In the tool, select the correct corresponding to your USB cable (you can check this in Device Manager). Set Upgrade Type to "All Code" or "Firmware". 5. Select the Firmware File Click the "Browse" or "Open" button in the software.
Navigate to and select the .abs firmware file you downloaded. 6. Start the Update Click the or "Upgrade" button. Immediately turn on your Satlink WS-6933 .
Launch the SatlinkTools or Upgrade.exe application on your PC. satlink ws-6933 software update
To avoid bricking your device (making it permanently unusable), gather all necessary tools and files before starting the process:
Knowing your current version will help you confirm if a new update is available.
Manufacturers periodically release firmware updates to address: Connect your meter to your PC
, you will need to use a PC to transfer the update file via USB. This process typically resets the device, meaning you will need to re-upload your satellite and transponder (TP) lists afterward.
: Power on the Satlink WS-6933 and connect it to your computer. The PC should recognize the device; if not, you may need to install specific COM port drivers.
Choose the "Download to Device" option and browse for the .bin firmware file you downloaded. : Run the Upgrade Tool In the tool, select
Cons
| Problem | Likely Fix | |--------|-------------| | “USB Not Supported” | Reformat USB to FAT32 (not exFAT/NTFS). Try a 4GB or 8GB drive. | | Device won’t turn on after update | Firmware mismatch. You may need a recovery file via RS-232. | | Update stuck at 0% | Corrupted file. Re-download and copy again. | | Remote control unresponsive after update | Perform factory reset. |
using the upgrade tool's "Dump" or "Read" function before overwriting anything.
Connect your Satlink WS-6933 to your PC using the Mini-USB cable. Turn the device on. If Windows does not automatically recognize the device, you must install the , depending on your specific hardware revision. Open your PC's Device Manager and verify that a COM Port is assigned to the meter (e.g., COM3). Step 2: Launch the Upgrade Tool
You can manually edit, add, or delete transponders directly on the device under the Transponder Setup