Eppendorf Centrifuge 5424 R Service Manual [patched] Jun 2026

Lena poked her head in. “Aris, the university lawyer called. They said if you open that, the warranty is void and they won’t cover a new one.”

: The "Fast Temp" function allows pre-cooling from 23 °C to the set temperature within 8 minutes. Maintenance Interface : Features a

This is a critical safety hazard. The manual states to immediately decommission the unit. Test the lid lock solenoid (Section 5.2). Resistance across solenoid coil should be 120 Ohms ± 10%. A lower reading indicates shorted windings, requiring replacement of the entire lid lock assembly (PN: 5820 704.112).

For more information on the Eppendorf Centrifuge 5424 R, including technical specifications, user manuals, and service resources, please visit the Eppendorf website or contact an authorized service provider. Eppendorf Centrifuge 5424 R Service Manual

Install the new latch and adjust the position until the lid locks with minimal pressure. Servicing the Drive Motor Remove the rotor and the chamber bottom plug.

The 5424 R is a refrigerated, benchtop centrifuge. The "R" signifies its refrigeration capabilities, allowing for temperatures from -10∘Cnegative 10 raised to the composed with power C +40∘Cpositive 40 raised to the composed with power C . Key features include: 21,130 x g (15,000 rpm).

Your centrifuge is an investment. The service manual is the insurance policy that protects it. Lena poked her head in

The service manual for the Eppendorf Centrifuge 5424 R provides detailed information on maintenance, troubleshooting, and repair procedures. It's essential for laboratory personnel to have access to this manual to ensure optimal performance, prevent downtime, and extend the lifespan of the centrifuge.

Allow the unit to cool for at least 15 minutes before restarting.

Avoid random PDF download sites. Many "free" manuals are either incomplete, for the wrong model (5424 vs 5424 R), or contain malicious malware. The genuine manual is typically 80–120 pages with detailed circuit schematics. Maintenance Interface : Features a This is a

Clean the condenser matrix of dust. If the problem persists, check the coolant levels and the compressor relay. 4. Disassembly and Component Replacement

Insert a calibrated digital thermometer probe into a water-filled microtube within the chamber. Run the centrifuge at 4°C for 20 minutes and confirm the internal probe reads within ±2°C of the display.

Locate the small circular opening on the front or side wall of the device.

| Specification | Detail | | :--- | :--- | | | 15,000 rpm | | Maximum RCF | 21,130 × g | | Maximum Capacity | 24 × 1.5/2.0 mL tubes | | Temperature Range | -10 °C to +40 °C | | Acceleration Time | Approx. 16 sec | | Deceleration Time | Approx. 18 sec | | Noise Level | < 51 dB(A) | | Power Consumption | 350 W (max) | | Dimensions (W x D x H) | 29 cm × 48 cm × 26 cm | | Weight | 21.0 kg |