Synchronizing the drive carriage with the motor electronics.

Ensure perfect horizontal alignment and tighten all, including front and rear clamping screws. 6. Installation: Door Connection (Page 6)

for three minutes after every cycle. Manual Release Procedure Pull down firmly on the red emergency release cord knob.

The control board LED will flash rapidly to confirm successful coding. Wait 10 seconds for the system to exit programming mode. 9. Operation and Safety Testing Testing Obstruction Detection Place a 50mm high solid object on the garage floor. Initiate a close cycle using the remote control. The door must reverse instantly upon striking the object.

An external manual release is mandatory if the garage lacks a second entrance. 5. Maintenance

To access internal terminal strips, lift away the primary terminal protection cover. Pass external wiring paths cleanly through the rubber cable gland built into the bottom structural plate.

to the start input for manual control.

: A minimum vertical distance of 40 mm must be present between the high point of the door travel arc and the ceiling. 2. Structural Preparation & Tools Needed

to output terminals to signal door movement.

Life Probo PR70: Installation, Use, and Maintenance Manual Section 1: Safety Instructions and Technical Specifications Safety Warnings

Ensure adequate room for performing manual release and maintenance operations. 2. Installation Instructions Installation requires prior assembly of the runner parts.

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.