Prosecure Opti Combi — Manual English

Keep the sensor lens clean and free of obstructions to ensure longevity and precise performance. Door will not close, LED is continuously Orange

. Ensure the sensor is mounted securely above the center of the door passage. Preparation: Dorma Opti Combi Mounting Guide to mark and drill holes. Connect the cable to the door operator (e.g., Dorma ES 200 Brown/White: Power supply (12–24V AC/DC). Green/Yellow: Activation output (Microwave). Pink/Grey: Safety output (Infrared). 2. Commissioning (The "Learning" Phase)

The is a high-performance combined sensor from dormakaba (formerly DORMA) designed specifically for automatic sliding doors . It integrates two detection technologies into a single unit: radar for motion-based activation and Active Infrared (AIR) for presence-based threshold safety. This dual functionality ensures compliance with safety standards like EN 16005 . Installation Overview

ON: Frequency B (Use when two sensors are mounted back-to-back to prevent crosstalk) OFF / OFF: 2 seconds ON / OFF: 30 seconds OFF / ON: 1 minute prosecure opti combi manual english

Configure the sensor to detect only approaching traffic (if required), ignoring departing traffic. 4. Operation and Maintenance 4.1 Daily Operation

This comprehensive manual provides complete technical instructions for installing, wiring, programming, and troubleshooting your ProSecure Opti Combi sensor using English-language programming standards. 1. Technical Specifications and Package Contents

Mount the sensor centrally directly above the moving leaves of the sliding door. Keep the sensor lens clean and free of

IP44/IP54 rated (depending on model) for resistance to dust and splashing water. Operating Voltage: Typically 12-24V AC/DC. 3. Installation Guide (English)

This often indicates the IR safety curtain is interrupted. Possible causes include:

The ProSecure Opti Combi is a high-performance, combined radar and infrared sensor used primarily for activating and securing automatic sliding doors. This comprehensive guide provides everything you need to install, program, and troubleshoot the sensor using the official English manual specifications. 1. Product Overview and Technical Specifications Preparation: Dorma Opti Combi Mounting Guide to mark

: Connect the cable to the door controller using the following standard terminal assignments: White : Ground / Negative (-) Brown : Power Supply (+) 11.5–32V DC or 12–24V AC Green : Common (COM)

Often used to initiate initialization or programming modes.

IP54 (suitable for external heading installation with proper weather protection) Temperature Range: -20°C to +60°C (-4°F to 140°F) 2. Installation and Mounting Steps

| Error Code / Symptom | Probable Cause | User Action | |----------------------|----------------|--------------| | (No water) | Water supply off or filter clogged | Check stop valve, replace filter | | E-05 (Probe error) | Core probe damaged or unplugged | Reconnect; if broken, replace | | E-12 (High temp) | Fan failure or blocked vents | Turn off, cool 30 min, restart | | Steam weak | Scale buildup in generator | Run descaling program | | Door won't close | Gasket misaligned or debris | Clean gasket and latch area |