: The finder will typically restart automatically once the upgrade is successful. Click "Finish" in the PC program to close the session. Important Precautions
Connect your USB-to-RS232 adapter to your PC. Windows may automatically install the drivers. To verify, open and expand the Ports (COM & LPT) section. Note the COM port number assigned to your cable (e.g., COM3). If a yellow exclamation mark appears, download and install the official drivers for your specific adapter chipset. Step 2: Connect the Hardware
Satellite frequencies change frequently. A software upgrade often includes refreshed transponder lists, preventing you from chasing dead frequencies.
Ensure the RS-232 driver is correctly installed on your computer. Try switching the COM port number to a lower one (e.g., COM1 or COM2) in Device Manager.
This is the desktop flashing software (usually named Upgrade.exe or Satlink Tool ). satlink ws6906 software upgrade
: Turn on the Satlink finder. The software should show a "Succeed connecting" message; click Load Firmware : Click the "Load Software" button and select your downloaded firmware file. Initiate Update "Start Upgrading."
Caution: Never flash firmware meant for the WS-6909, WS-6916, or other models onto the WS-6906. Step-by-Step Satlink WS-6906 Firmware Update Process
: Once finished, the finder will restart automatically, indicating a successful upgrade. Safety Warnings
Plug your RS-232 to USB cable into a vacant USB port on your desktop or laptop computer. : The finder will typically restart automatically once
Turn the Satlink meter off, disconnect the data cable, and turn it back on to complete the reboot sequence. Troubleshooting Common Upgrade Errors
Launch the upgrade software on your PC. Configure the connection settings exactly as follows:
Open your upgrade software on the PC. You will need to select the correct (usually found in your PC’s Device Manager). Set the "Operate Mode" to "Upgrade" and select the firmware file you downloaded. 4. The Flash Process Keep the Satlink WS-6906 OFF initially. Click "Start" on the PC software. Turn the Satlink power switch to ON .
Always perform a "data dump" of your current firmware before flashing a new one so you have a recovery point. Windows may automatically install the drivers
The upgrade software is generally designed for Windows.
: Wait approximately 1–2 minutes for the process to complete. Do not turn off the power or disconnect the cable during this time.
Before initiating the firmware flash, assemble these physical and digital components:
Click and then "Write Parameters" to save the new list to your meter. Troubleshooting Common Issues