Digi Sm320 Service Manual -

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. SM-320 Scale Specifications Overview | PDF - Scribd

To access the Spec alteration screen, enter , hold down the Rezero key, and type 1, 4, 1 . Spec Number Configuration Purpose Valid Parameter Options SPEC 2 Price presentation structures 0 = Tax Exclusive Price; 1 = Tax Inclusive Price SPEC 135 Fixed scale local identifier assignment Unique numeric values ranging from 1 to 255 Barcode Spec Formatting of data matrix values 5 = Embed Weight / Quantity values within printed barcodes Assigning IP Addresses and Subnet Masks

Persistent software glitches or communication freezes can often be resolved by initiating a hard factory reset. Note that . Turn the power switch OFF .

By providing explicit error codes, calibration secrets, wiring diagrams, and disassembly instructions, the service manual pays for itself the first time you avoid an unnecessary service call. digi sm320 service manual

Locate the small calibration access plate (usually on the underside or beneath the platter area, protected by a lead or plastic seal).

Locate the physical (often protected by a calibration seal or small access plate on the underside or side of the scale). Turn the Span Switch to the ON (Calibration) position.

Standard configuration includes RS-232 serial ports, an Ethernet port (RJ45), and a cash drawer interface. Accessing Service Mode (Span Switch) This public link is valid for 7 days

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

After removing top shield (4 screws):

Label and disconnect the interface ribbons from the main logic board (Main PCB). 4. Calibration & Configuration Procedure Can’t copy the link right now

Align the pole with the fixing locations and replace the screws. Service and Calibration Procedures

The analog signal from the load cell is out of the acceptable range (too high or too low).

Warning: This erases all PLUs, custom label formats, network configurations, and calibration data. Turn off the power switch.

The system will process the span value and return to the normal weighing mode interface. ⚙️ Spec Configurations & Network Setup